Manualshelf

User manual

ManualsBrandsSOFTING ManualsTest EquipmentNetXpert 1400 NX1400 LAN Qualifier, Cable tester, Cable qualifier Calibrated to Manufacturer's standards (no c
11121314151617181920
18
The Active Remote is used with the NetXpert 1400 to perform a
speed certification test. The Active remote can be configured to
display 1-4 remote ID’s
• Press the Status button to display the battery percentage and the
Pass/Fail result of the previous cable test.
• To set the remote ID, remove the battery door screws (see Active
Remote on pg.8) and remove the battery door).
• Gently pull out the battery (it is not necessary to unplug the
battery to access the ID indicator switch.
WARNING! Do not pull on the battery wires as this may damage
the battery. If the battery is removed, use caution as it plugs
in one way. Do not force the plug in to the remote as this will
damage the plug and/or remote.
• Push the desired ID switch up and push the other keys down (see
image below).
ACTIVE REMOTE
Remote set to ID 1