Manualshelf

User manual

ManualsBrandsSOFTING ManualsTest EquipmentNetXpert 1400 NX1400 LAN Qualifier, Cable tester, Cable qualifier Calibrated to Manufacturer's standards (no c
11121314151617181920
16
Install NetXpert 1400 Update:
• From the home screen, Touch System Settings .
• Touch More Settings or press the Settings button
until the
firmware screen is displayed (6th settings screen).
• Update by touching the rmware le in the rmware table then
touch Update Firmware
on the screen. A new screen will
appear, confirming that you are updating firmware. Touch OK
to continue or Cancel. Another window will appear: Updating
firmware.
Warning: System will reboot after update. Please make sure
battery is not low.
Press OK to continue or Cancel.
• To reset to the factory rmware, touch the Reload Factory
Firmware
. A new screen will appear, confirming that you
are deleting the firmware update and restoring to factory default.
You will be prompted to touch OK to continue or Cancel to cancel.
NetXpert 1400 will then restart.
• To reset to the factory settings, touch the Reset Settings
. A
new screen will appear, confirming that you are restoring factory
Cable Type list. You will be prompted to touch OK to continue or
Cancel to cancel.