User manual

15
Upload NetXpert 1400 firmware using the Micro USB cable:
• Plug the included micro USB cable into the NetXpert 1400 then
plug the other end of the cable into your computer.
• Touch File Manager .
• Touch More Options .
• Touch USB . The NetXpert 1400 will reboot into File Transfer
Mode as shown in the image below.
• The NetXpert 1400 will be recognized by your computer as a
removable drive. If your computer does not automatically prompt
you to view the removable drive, click on the windows start menu,
click on “Computer”, and then double click on the removable
drive.
Note: The removable drive may be listed in “Computer” as an SD
Card, as the NetXpert 1400 simulates an SD Card reader.
• Navigate to the rmware le that was saved to the computer from
www.psiberdata.com. Right click on the firmware file then click
on “Copy”.
• Navigate back to the NetXpert 1400 removable drive and right
click in the removable drive window and click on “Paste”.
• Close the removable drive window then click on “safely remove
hardware” on your computers toolbar on the bottom left. Eject
“MQX Mass Storage Device”.
• Remove the micro USB cable from the NetXpert 1400.
• The NetXpert 1400 will automatically reboot. Follow the intructions
below to complete the udate.