User manual

6. System Settings Screen (Firmware)

You can have more than one version of rmware on the SD card –

all ﬁrmware ﬁles on the SD Card will be displayed on this screen.

Use the Up and Down buttons to scroll through multiple

ﬁrmware ﬁles.

• The factory installed rmware revision (default rmware) is

displayed above the ﬁrmware ﬁle table.

• The current rmware revision that is being used is displayed

above the ﬁrmware ﬁle table Current x.xx.

How to update the NetXpert 1400 Firmware:

Warning! Do not update the ﬁrmware if the battery charge is less

than 50%, unless the NetXpert 1400 is plugged in to A/C power.

• Go to www.psiberdata.com

• Download the rmware le to your computer. Take note of where

the Firmware ﬁle is saved.

Upload ﬁrmware using the SD Card:

• Remove the SD Card (located on the left side of NetXpert 1400)

and insert it into your computer using an SD Card reader. Your

computer will recognize the SD Card as a removable drive. Open

the removable drive folder and copy the ﬁrmware ﬁle from your

computer to the removable drive window. Re-insert the SD Card

into the NetXpert 1400. Proceed Installation; “NetXpert 1400

Update” below to install complete the update.

Note: When installing SD Card with ﬁrmware update refresh the

ﬁrmware table by exiting and then reentering the ﬁrmware screen.