User manual

10
The NetXpert 1400 Setup consists of seven screens to configure
the unit to the user’s preference. Use the Settings button to
navigate through the settings screens.
1. System Settings Screen: IPV4 Setup
In the IPV4 setup screen, the NetXpert 1400’s network tests can be
configured to use DHCP or a Static IP addresses. The NetXpert 1400
can also be set to use a DHCP provided DNS or a fixed DNS IP.
• Turn the NetXpert 1400 on by pressing the Power button
.
• Touch System Settings on the home screen.
• “Use DHCP” is set as default. To enter static IP’s touch “Use
Static IP” and enter the following:
- Touch “Set IP” and enter the NetXpert 1400 IP address using
the numeric keypad, then touch OK.
- Touch “Set Subnet Mask” and enter the Subnet Mask IP
address using the numeric keypad, then touch OK.
- Touch “Set Gateway” and enter the Gateway IP address,
then touch OK.
• Use “DHCP DNS” is set as default. To manually enter DNS
addresses, touch “Choose DNS”.
• Touch “Set DNS” and use the numeric keypad to enter a
preferred DNS IP address and touch OK.
SYSTEM SETTINGS