User manual

English
How to Perform a Cable Test
• Power on the CableMaster 600/650.
• Connect a network, coax, or telephone cable to the appropriate connector
on the top of the CableMaster 600/650.
(Warning! Do not plug an RJ11 cable directly into the CableMaster 600/650!
A standard RJ11 cable will damage the CableMaster 600/650’s RJ45 jack.
Use the included RJ adapter patch cable (CA012) that is included with the
CableMaster 600/650.)
• Press the enter button to display the cable test menu. The CableMaster
600/650 will automatically perform a test upon entering the cable test menu.
• To test coax or telephone cable, press the coax or telephone soft key.
• If a remote is NOT being used (one ended test), the CableMaster 600/650 will
test the length of each pair, opens, shorts, or split pairs. Performing a one
ended test will not verify connectivity on the opposite end of the cable.
• If a remote is being used, connect the remote to the opposite end of the
cable.
• To calibrate the NVP, connect a known length of cable to the CableMaster
600/650 and press the up/down/left/right buttons to increase or decrease
the NVP. Press the left and right buttons to select and change the NVP one
digit at a time.
• While adjusting the NVP, press the test button every so often until the length
of the cable is displayed.
• Press the green test button or the loop mode soft key to
perform additional tests.
• To save a cable test, press the save icon.
• Use the arrow buttons and the enter button to name the cable test file.
• Press the save icon to save the cable test file.