User manual

Stress Test Screen
Select the STRESS TEST button from the HOME screen. This screen
displays the port link connection and the IP address associated with that
port. All Stress Test packets are sent to either the second port on the
LANEXPERT or another LANEXPERT. The IP address for the other
port or the second LanExpert must be entered in the Stress Test
Setup and is shown as the Remote IP address.
There is a button under the Remote IP address labeled LOCAL-> REMOTE
or REMOTE -> LOCAL. This describes where the packets originate from.
Selecting LOCAL-> REMOTE describes the packet originates from the
Local LANEXPERT and is sent to the remote LANEXPERT. This gives
us an upstream configured test.
Selecting REMOTE -> LOCAL describes the packet originates from the
Remote LANEXPERT and is sent to the Local LANEXPERT. This gives
us an downstream configured test.
Select from one to four test(s) to be performed. The estimated time for
each test is given. Select START to begin the test(s). Stopping a test
before it is complete may give invalid results.
Stress test Screen
5-4
Stress Test
Stess Test Screen
Start/Stop
Select START in the data action buttons to start the selected tests. The
LANEXPERT tests the connection to the remote IP address to ensure a
valid IP was entered. If an invalid IP address was entered then the
LanExpert displays an error message saying <REMOTE DEVICE
NOT FOUND> and returns to the stress test screen where the remote IP is
now in red. Select a valid IP address (either from PORT 2 or another
LANEXPERT on the network). Select STOP in the data action buttons to
stop the test.
Chapter 5
Stress test Screen with
invalid IP address