User manual

Basic Setup
This section will describe how to configure the LANEXPERT for a
RFC2544 Stress Test.
5-3
Stress Test
Stess Test Screen
Stress Test with Two LanExperts
Select SETUP on both LANEXPERTs and select Factory Default under
the Select Profile. Press [X] to return to the Home Screen.
Select Stress Test and wait for both LANEXPERTs to link. On the main
LANEXPERT (the one where you will press start), Select Setup and
change the Remote IP address to the other LANEXPERT IP address
(Remote LANEXPERT).
Select START to start the Stress test with the configuration set under
Stress Test setup. Select the RESULTS button to see the results of the
test.
Chapter 5
NOTE: If you are not connected to a network that has DHCP or con-
nected directly into the other LANEXPERT with a cable, you must select
a fixed IP address for both of the LANEXPERT . Make sure the IP
address are within ths same subnet mask.
NOTE: Since stress testing does not (and cannot by definition) respond
to pause frames, it cannot be slowed down. This means you cannot
perform stress testing on an active network. Remember, stress testing
has a zero tolerance to lost frames – just a single frame lost is a failure
of the test.