User manual

Basic Setup
This section will describe how to configure the LANEXPERT for a
RFC2544 Stress Test.
5-2
Stress Test
Stess Test Screen
Stress Test with One LanExpert
Select SETUP and select any Profile besides Factory Default under the
Select Profile. Go to PORTS and change the configuration to INDEP for
Independent mode.
Chapter 5
NOTE: If you are not connected to a network that has DHCP or con-
nected directly into the other port of the LanExpert with a cable, you must
select a fixed IP address that has the same subnet mask as Port 2.
If you are not connected to a network that has DHCP, press the DOWN
arrow twice to display Port 1 IP address. Select FIXED and give PORT 1 an
IP address, Subnet and Gateway IP address.
Press the DOWN arrow three more times to display Port 2 IP address.
Select FIXED and give PORT 2 an IP address which is in the same subnet
mask as Port 1. Select the same Subnet Mask and Gateway IP address as
Port 1.
For Example,
Port 1 IP address 192.125.1.100
Subnet Mask 255.255.255.0
Gateway 192.125.1.1
Port 2 IP address 192.125.1.101
Subnet Mask 255.255.255.0
Gateway 192.125.1.1
Make sure to change the Remote IP address to Port 2 IP address.
Select STRESS TEST under setup to change the Remote IP.