User manual

4-29
Chapter 4
Analyze Network
PoE
Inline PoE
Select the PoE button in the Bottom Area. This is INLINE PoE, which is not
the same as the PoE under cable test. By selecting this button, make sure
the LANEXPERT is in INLINE mode or a screen will be displayed saying
<Only available when configured in inline mode>. Make sure one side of
the LANEXPERT is a Powered device and the other side a Power
Source.
This screen will show whether the Power is Midspan (power on 45-78),
Endspan (power on 12-36) or allspan (power on 12-36 and 45-78)
depending on where the voltage is detected.
Inline currnet is displayed in mA along with the Power in watts and the
flow of current going from the source to the device. In this case the
current flow is going from P2 and is powering up P1.
NOTE: Select another Test button visible on the screen or by scrolling to
the right or left with the white arrows or select the Exit button.
Example Inline PoE
Screen