User manual

4-13
Chapter 4
Analyze Network
Protocols - cont.
NOTE: Select another Test button visible on the screen or by scrolling to
the right or left with the white arrows or select the Exit button.
Total
avg/s - shows the average of protocols collected per second.
/1s - shows protocols that were collected within the last
second. This will update every second.
/10s - shows protocols that were collected within the last 10
seconds. This will update every 10 seconds.
/1m - shows protocols that were collected within the last minute.
This will update every minute.
Total - shows all protocols that were collected since the link was
established.
The TOTAL button in the Data Action Area is used to change how the
information is presented. The amount of protocols collected will be
presented in the time frames selected. This function works in both the List
and Chart mode.
The choices below are how the information can be presented:
Clear
Select CLEAR in the data action buttons to clear all the detected protocols.
List/Chart
Select LIST in the Data Action buttons. This will display the percentage of
each protocol in a bar chart format. These colored bars show the
percentage of the each protocol received. Each bar is logarithmically set in
length and is horizontal (there are 0.1%, 1%, 10%, 100% markers shown in
the first line of the data area which cannot be changed).
Select CHART in the Data Action buttons. The LIST will be displayed again
showing the good and bad frame counts and percentages.