User manual

2-4
Getting Started
Using the Analyzer for the First Time
Using the Analyzer for the First Time
Power on
Turn on the LANEXPERT by pressing the power button until the
screen lights up, then release the button. The unit displays the
welcome screen for approximately 3 seconds. The firmware
versionis shown on this screen.
If Security is enabled, then a Username and Password must be
entered before the HOME screen can be displayed. If the incorrect
username or password is entered, an error screen stating “Invalid
Log on no Matching Account” appears, and then returns back to the
log on screen. If the correct username and password is entered the
LanExpert displays a green screen saying “Logged on as Admin or
User #”, depending on what was entered.
If Security is disabled, the HOME screen comes up automatically.
Chapter 2
Log On Screen if Security
was already set up.
Straight to Home Screen if
Security is disabled
Logged On as Admin Screen
NOTE: There is no way to get the username or password back
from the LanExpert so write down the the entered data or the
LanExpert will need to be returned to the factory for Service.
(Service fee will apply).