User Manual

13
Pictorial Symbols
Refer to the labels on each product (the machine, battery charger, battery).
Each is compliant with the Japanese
Electri cal Appliances and Material
Safety Act (Spec ified Electrical
Appliances and Materials).
Incorporates a specified wireless system
as defined by Japanese law (TELEC or
JATE-cer tified).
Do not short-circuit. Do not disassemble.
Do not immerse in water or other
liquid.
Machine Disposal and Recycling
The product you have purchased is designed and manufactured with recyclable, high-quality materials and
components. When disposing of the product, check that it is being disposed of properly as industrial waste
differentiated from general and business waste according to regional and municipal regulations by request to an
industrial waste disposal operator.
* If the product is being leased, it cannot be disposed of by yourself. Contact customer support. When disposing
of the machine, remove the battery from the machine, and dispose of properly according to regulations for waste
disposal in the region you are residing in.
FCC Compliance
This product complies with section 15 of FCC Regulations. Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.This
equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must
follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be
colocated or operating in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the
FederalCommunications Commission (USA). This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.