Operation Manual

57
Checking Precautions when Teaching a Cleaning Route
Be sure to check the following before teaching a cleaning route.
 Machine
 Always carry out an inspection before operating the machine (⇒see “Inspection before Operating the Machine”). Do not bring the
machine too close to a wall when teaching a cleaning route.
 As the machine may detect nearby persons as objects, do not stand in front of the sensor, and teach cleaning routes at a time
when few persons are around.
 Do not use the machine where there is direct sunlight, where there is strong lighting, or near devices that emit infrared light
(heaters, etc.). Doing so may affect its autonomous cleaning function.
 When teaching a cleaning route, move the machine forward. *Reverse movement will not be recognised as a cleaning route.
 The machine will push against thin mats that slide easily, and may damage the mat or brush. Remove any mats before teaching
a cleaning route.
 Floors with an uneven, rough surface cannot be detected during auto cleaning. As bumpy floors may be recognized as obstacles,
avoid cleaning rough-surface floors.
 A passageway of more than 80cm in width is needed in order for Whiz to operate autonomously at an optimum speed. *If the
width of the passageway is below 80cm, the machine may recognize as an obstacle and the speed may decrease or the machine
may stop.
 When operating several machines, their sensors may cross-interfere with each other.