Operation Manual

52
Whiz Operational Manual
Inspection before Operating the Machine
Before starting manual cleaning mode/autonomous cleaning mode, be sure to perform the following inspection.
 Inspecting the Machine
 Check that the emergency stop button is not pressed
 Check that the grounding chain on the bottom of the machine is in contact with the floor
 Check that the Secondary battery power button on the bottom of the machine is on (⇒see “Secondary battery power button”)
 Check the HEPA filters, and replace with new HEPA filters if especially dirty (⇒see “HEPA Filters”)
 Check the hopper tray and empty it (⇒see “Hopper Tray”)
 Check that there is no dust or dirt on the 2D/3D camera (sensor), LIDAR sensor, or Cliff sensors and wipe as required (⇒see
“Sensors”)
・ Use the micro-fiber cloth to wipe away any dust or dirt.
* Do not wet any of the above sensors or the micro-fiber cloth with water
・ Do not place any objects near the sensors.
Check the brush for caught dust and hair, and remove as required (⇒see “Brush”)
 Check that the brush is attached properly
・ If the brush is damaged/broken, replace with a new brush.
 Check that the dustbin cover, filter cover, and battery door are closed firmly
 Inspecting the Cleaning Area
 Check that the cleaning area is an environment where cleaning is possible
・ The machine is not water resistant. Use the machine in a dry location.