Specifications

Alarm
After 3 consecutive time of wrong code, your safe will activate the alarm system, the alarm will sound , then enter the
correct password and the alarm will be cancelled.
Press“*” enter the alarm state, voice prompts “alarm on”. When the safe is alarming, enter the right user code or finger-
print to deactivate the alarm.
When power on, the system default for alarm is off.
When the door is opened, the alarm is turned off and needs to be turned on again.
System Reset
Press and hold setting button for 3 seconds, voice prompt: “restore factory setting successfully”.
User code, master code is initialized. Fingerprints deleted.
Undervoltage
When the power supply voltage is lower than 5 V (±0.2V), when the system exits, the “LOW” indicator light will on.
Step 2 setting the fingerprint
1.Set your fingerprint, press “2”, The voice prompt "Please press fingerprint", and then place the finger to be registered on the
fingerprint collector. When you hear the "please re-enter " prompt, remove your finger and press again, the "RIGHT" light will
blink and the voice prompts " register success. (press twice when register, maximum 30 fingerprints can be registered)
2.Delete fingerprint, press “3”, “RIGHT”indicator light on，voice prompts “delete success”, then the fingerprints have been
deleted successfully.
Step 3 Set master code
Press “4” to set master code, please follow the same procedures for setting user code.
Step 4 Set door open mode
Press “5” to set door open mode
1. Common mode press“1”,（enter user code or fingerprint to open）
2..Safe mode press“2”.(enter user code and fingerprint open)
Press“*” to exit.
How to use emergency battery box
OPEN
When the safe box’s battery is too low to open the door, insert 4AA batter-
ies in the emergency battery box, plug the emergency power cord into the
emergency power jack on the bottom edge of the panel, then enter the
correct password to open the door.
1. place the safe at the installation place,.Mark the drilling spots on the wall from
the inside pre-drilled holes, then remove safe and drill two holes.
2.Put the expansion bolts into the drilled holes, take the expansion bolt out of the
sleeves , then place the safe and align the pre-drilled holes with drilled holes, and
insert the expansion bolts into its sleeves from inside of the safe.
(This safe has four mounting holes, two are on the back of the safe and the others
are on the bottom of the safe)
How to install foot mat?
1.Remove the stickers of the four
foot mats
2.install the four foot mats on the
bottom of the safe
How to mount the safe?
SECURITY
1
2 3
4 5 6
7
*
0 #
RIGHT
SET
LOW
8 0
ERROR