User's Manual Part 3

Using RADIUS Authentication
374 Check Point Safe@Office User Guide
A confirmation message appears.
b) Click OK.
The RADIUS settings are reset to their defaults. For information on the
default values, refer to the table below.
5. To use the RADIUS VSA to assign permissions to users, configure the VSA.
See Configuring the RADIUS Vendor-Specific Attribute on page 376.
Table 76: RADIUS Page Fields
In this field… Do this…
Primary/Secondary
RADIUS Server
Configure the primary and secondary RADIUS servers.
By default, the Safe@Office appliance sends a request to the primary
RADIUS server first. If the primary RADIUS server does not respond
after three attempts, the Safe@Office appliance will send the request to
the secondary RADIUS server.
Address Type the IP address of the computer that will run the RADIUS service
(one of your network computers) or click the corresponding This
Computer button to allow your computer to host the service.
To clear the text box, click Clear.
Port Type the port number on the RADIUS server’s host computer.
The default port number is 1812.
Shared Secret Type the shared secret to use for secure communication with the
RADIUS server.