User's Manual Part 1

Configuring High Availability
130 Check Point Safe@Office User Guide
Gateway A will reduce its priority by 30, if its secondary Internet connection
goes down.
l. Click Apply.
A success message appears.
6. Do the following on Gateway B:
a. Set the gateway's internal IP addresses and network range to the
values specified in the table above.
See Changing IP Addresses on page 107.
b. Click Setup in the main menu, and click the High Availability tab.
The High Availability page appears.
c. Select the Gateway High Availability check box.
The Gateway High Availability area is enabled. The LAN and DMZ networks
are listed.
d. Next to LAN, select the HA check box.
e. In the LAN network's Virtual IP field, type the default gateway IP
address 192.168.100.3.
f. Next to DMZ, select the HA check box.
g. In the DMZ network's Virtual IP field, type the default gateway IP
address 192.168.101.3.
h. Click the Synchronization radio button next to DMZ.
i. In the My Priority field, type "60".
The low priority means that Gateway B will be the Passive Gateway.
j. In the Internet - Primary field, type "20".
Gateway B will reduce its priority by 20, if its Internet connection goes
down.
k. Click Apply.
A success message appears.