User Manual Part 2
Table Of Contents
- Using SmartDefense
- Using Antivirus and Antispam Filtering
- Overview
- Using VStream Antivirus
- Using VStream Antispam
- How VStream Antispam Works
- Header Marking
- Default Antispam Policy
- Enabling/Disabling VStream Antispam
- Viewing VStream Antispam Statistics
- Configuring the Content Based Antispam Engine
- Configuring the Block List Engine
- Configuring the IP Reputation Engine
- Configuring the VStream Antispam Policy
- Configuring the Safe Sender List
- Configuring VStream Antispam Advanced Settings
- Using Centralized Email Filtering
- Using Web Content Filtering
- Updating the Firmware
- Using Subscription Services
- Working With VPNs
- Overview
- Setting Up Your Safe@Office Appliance as a VPN Server
- Adding and Editing VPN Sites
- Viewing and Deleting VPN Sites
- Enabling/Disabling a VPN Site
- Logging in to a Remote Access VPN Site
- Logging Out of a Remote Access VPN Site
- Using Certificates
- Viewing VPN Tunnels
- Viewing IKE Traces for VPN Connections
- Viewing VPN Topology
- Managing Users
- Using Remote Desktop
- Controlling the Appliance via the Command Line
- Maintenance
- Viewing Firmware Status
- Upgrading Your Software Product
- Configuring a Gateway Hostname
- Configuring Syslog Logging
- Configuring HTTPS
- Configuring SNMP
- Setting the Time on the Appliance
- Using Diagnostic Tools
- Backing Up and Restoring the Safe@Office Appliance Configuration
- Using Rapid Deployment
- Resetting the Safe@Office Appliance to Defaults
- Running Diagnostics
- Rebooting the Safe@Office Appliance
- Using Network Printers
- Troubleshooting
- Specifications
- Glossary of Terms
- Index
Configuring SSH
680 Check Point Safe@Office User Guide
If you selected Internal Networks + IP Range, additional fields appear.
3. If you selected Internal Networks + IP Range, enter the desired IP address range
in the fields provided.
4. Click Apply.
The SSH configuration is saved. If you configured remote SSH access, you can now
control the Safe@Office appliance from the Internet, using an SSHv2 client.
For information on all supported commands, refer to the Embedded NGX CLI
Reference Guide.