User Manual Part 2

Using the Serial Console
676 Check Point Safe@Office User Guide
Using the Serial Console
You can connect a console to the Safe@Office appliance, and use the console to control
the appliance via the command line.
Note: Your terminal emulation software and your Safe@Office appliance's Serial
port must be configured for the same speed.
By default, the appliance's Serial port's speed is 57600 bps. For information on
changing the Serial port's speed, refer to the Embedded NGX CLI Reference
Guide.
To control the appliance via a console
1. Connect the serial console to your Safe@Office appliance's Serial port, using
an RS-232 Null modem cable.
For information on locating the Serial port, see Rear Panel.
2. Click Network in the main menu, and click the Ports tab.