User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Securing the Safe@Office Appliance against Theft
Chapter 3: Installing and Setting Up Safe@Office 65
Your Safe@Office appliance is wall mounted. You can now connect it to your
computer.
Securing the Safe@Office Appliance against Theft
The Safe@Office appliance features a security slot to the rear of the right panel, which
enables you to secure your appliance against theft, using an anti-theft security device.
Note: Anti-theft security devices are available at most computer hardware stores.
This procedure explains how to install a looped security cable on your appliance. A looped
security cable typically includes the parts shown in the diagram below.
Figure 14: Looped Security Cable