User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Appliance Installation
Chapter 3: Installing and Setting Up Safe@Office 61
service. Check with your service provider whether a micro-filter is required at
your location.
4. To use the appliance with a non-ADSL connection, or with an existing ADSL
modem, connect an Ethernet cable:
a. Connect one end of the Ethernet cable to the appliance's DMZ/WAN2 port.
b. Connect the other end of the cable to an external cable modem, DSL
modem, or office network.
5. Connect the power supply to the appliance's power socket, labeled PWR.
6. Plug the power supply into the wall electrical outlet.
Warning: The Safe@Office appliance power supply is compatible with either 100,
120 or 230 VAC input power. Verify that the wall outlet voltage is compatible with
the voltage specified on your power supply. Failure to observe this warning may
result in injuries or damage to equipment.
Figure 13: Typical Connection Diagram