User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Before You Install the Safe@Office Appliance
54 Check Point Safe@Office User Guide
TCP/IP Settings
1. In the Local Area Connection Properties window, double-click the Internet
Protocol (TCP/IP) component, or select it and click Properties.
The Internet Protocol (TCP/IP) Properties window opens.
2. Click the Obtain an IP address automatically radio button.
Note: Normally, it is not recommended to assign a static IP address to your PC but
rather to obtain an IP address automatically. If for some reason you need to assign
a static IP address, select Specify an IP address, type in an IP address in the range of
192.168.10.129-254, enter 255.255.255.0 in the Subnet Mask field, and click OK to
save the new settings.
(Note that 192.168.10 is the default value, and it may vary if you changed it in the
Network > My Network page.)
3. Click the Obtain DNS server address automatically radio button.
4. Click OK to save the new settings.
Your computer is now ready to access your Safe@Office appliance.