User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Before You Install the Safe@Office Appliance
Chapter 3: Installing and Setting Up Safe@Office 49
The Local Area Connection Properties window opens.
6. Check if Internet Protocol Version 4 (TCP/IPv4) appears in the list box and if it
is properly configured with the Ethernet card installed on your computer.
TCP/IP Settings
1. In the Local Area Connection Properties window, double-click the Internet
Protocol Version 4 (TCP/IPv4) component, or select it and click Properties.
The Internet Protocol Version 4 (TCP/IPv4) Properties window appears.
2. Click the Obtain an IP address automatically radio button.