User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Before You Install the Safe@Office Appliance
Chapter 3: Installing and Setting Up Safe@Office 45
Chapter 3
This chapter describes how to properly set up and install your Safe@Office appliance in
your networking environment.
This chapter includes the following topics:
Before You Install the Safe@Office Appliance .........................................45
Appliance Installation.................................................................................59
Wall Mounting the Sa
fe@O
ffice Appliance...............................................63
Securing the Safe@Office Appliance
against Theft...................................65
Setting Up the Safe@O
ffice Appliance......................................................67
Before You Install the Safe@Office Appliance
Prior to connecting and setting up your Safe@Office appliance for operation, you must do
the following:
• Check if TCP/IP Protocol is installed on your computer.
• Check your computer’s TCP/IP settings to make sure it obtains its IP address
automatically.
Refer to the relevant section in this guide in accordance with the operating system that runs
on your computer. The sections below will guide you through the TCP/IP setup and
installation process.
Installing and Setting Up Safe@Office