User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Getting to Know Your Safe@Office 500W ADSL Appliance
Chapter 1: Introduction 29
Table 10: Safe@Office 500 ADSL Appliance Status LEDs
LED State Explanation
PWR/SEC Off Power off
Flashing quickly (Green) System boot-up, or rapid deployment
in progress
Flashing slowly (Green) Establishing Internet connection
Flashing (Red) Hacker attack blocked, or error
occurred during rapid deployment
process
On (Green) Normal operation
On (Red) Error
LAN 1-4/
DMZ/WAN2
LINK/ACT Off, 100 Off
Link is down
LINK/ACT On, 100 Off
10 Mbps link established for the
corresponding port
LINK/ACT On, 100 On
100 Mbps link established for the
corresponding port
LNK/ACT Flashing
Data is being transmitted/received
DSL
Link Off
Link is down
Link Flashing
Establishing ADSL connection
Link On
ADSL connection established
DAT Off
ADSL line is idle
DAT Flashing
Data is being transmitted/received