User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Using Rules
Chapter 13: Setting Your Security Policy 369
In this field… Do this…
Protocol Select the protocol for which the rule should apply (ESP, GRE, TCP, UDP,
ICMP, IGMP, or OSPF).
To specify that the rule should apply for any protocol, select ANY.
To specify a protocol by number, select Other. The Protocol Number field
appears.
Port Range To specify the port range to which the rule applies, type the start port number
in the left text box, and the end port number in the right text box.
Note: If you do not enter a port range, the rule will apply to all ports. If you
enter only one port number, the range will include only that port.
Protocol Number Type the number of the protocol for which the rule should apply.
Source Select the source of the connections you want to allow/block. This list
includes network objects.
To specify an IP address, select Specified IP and type the desired IP address
in the field provided.
To specify an IP address range, select Specified Range and type the desired IP
address range in the fields provided.
To specify the Safe@Office IP address, select This Gateway.
To specify any source, select ANY.