User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Using Rules
Chapter 13: Setting Your Security Policy 361
For example, if you want to block all outgoing FTP traffic, except traffic from a specific IP
address, you can create a rule blocking all outgoing FTP traffic and move the rule down in
the Rules table. Then create a rule allowing FTP traffic from the desired IP address and
move this rule to a higher location in the Rules table than the first rule. In the figure below,
the general rule is rule number 2, and the exception is rule number 1.
The Safe@Office appliance will process rule 1 first, allowing outgoing FTP traffic from
the specified IP address, and only then it will process rule 2, blocking all outgoing FTP
traffic.
The following rule types exist: