User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Viewing Computers
Chapter 11: Viewing Reports 317
blocked from accessing the Internet through the Safe@Office appliance, the reason
why it was blocked is shown in red.
If a network is bridged, the bridge's name appears in parentheses next to the network's
name.
If you are exceeding the maximum number of computers allowed by your license, a
warning message appears, and the computers over the node limit are marked in red.
These computers are still protected, but they are blocked from accessing the Internet
through the Safe@Office appliance.
Note: Computers that did not communicate through the firewall are not counted for
node limit purposes, even though they are protected by the firewall and appear in
the Active Computers table.
Note: To increase the number of computers allowed by your license, you can
upgrade your product. For further information, see Upgrading Your Software
Product on page 685.
If Secure HotSpot is enabled for some networks, each computer's HotSpot status is
displayed next to it. The possible statuses include:
• Authenticated. The computer is logged in to My HotSpot.
• Not Authenticated. The computer is not logged in to My HotSpot.
• Excluded from HotSpot. The computer is in an IP address range excluded from
HotSpot enforcement. To enforce HotSpot, you must edit the network object.
See Adding and Editing Network Objects on page 187.
If Re
m
ote Desktop is enabled, a link appears next to each computer, enabling you to
access its desktop remotely. For information on using Remote Desktop, see Using
Remote Desktop on page 661.
Next to each com
puter, an Add button enables you to add a network object for the
computer, or an Edit button enables you to edit an existing network object for the
computer. For information on adding and editing network objects, see Adding and
Editing Network Objects on page 187.
2. To refresh the display
,
click Refresh.
3. To view node limit information, do the following:
a. Click Node Limit.