User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Using the Traffic Monitor
Chapter 11: Viewing Reports 313
3. To refresh all traffic reports, click Refresh.
4. To clear all traffic reports, click Clear.
Note: The firewall blocks broadcast packets used during the normal operation of
your network. This may lead to a certain amount of traffic of the type "Traffic
blocked by firewall" that appears under normal circumstances and usually does not
indicate an attack.
Configuring Traffic Monitor Settings
You can configure the interval at which the Safe@Office appliance should collect traffic
data for network traffic reports.
To configure Traffic Monitor settings
1. Click Reports in the main menu, and click the Traffic tab.
The Traffic Monitor page appears.
2. Click Settings.