User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Wireless Networks
296 Check Point Safe@Office User Guide
6. In the Type drop-down list, select Virtual Access Point.
New fields appear.
7. In the Mode drop-down list, select Enabled.
The fields are enabled.
8. In the IP Address field, type the IP address of the VAP network's default
gateway.
The VAP network must not overlap other networks.
9. In the Subnet Mask field, type the VAP's internal network range.
10. If desired, enable or disable Hide NAT.
See Enabling/Disabling Hide NAT on page 157.
11. If desired, configure a DHCP server.