User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Wireless Networks
Chapter 10: Working with Wireless Networks 291
In this field… Do this…
Wireless Transmitter
Transmission Rate Select the transmission rate:
• Automatic. The Safe@Office appliance automatically selects a
rate. This is the default.
• A specific rate
This field only appears when configuring the primary WLAN, and it is
inherited by all VAPs and WDS links.
Transmitter Power Select the transmitter power.
Setting a higher transmitter power increases the access point's range. A
lower power reduces interference with other access points in the vicinity.
The default value is Full. It is not necessary to change this value, unless
there are other access points in the vicinity.
This field only appears when configuring the primary WLAN, and it is
inherited by all VAPs and WDS links.