User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Wireless Networks
276 Check Point Safe@Office User Guide
• To bridge the LAN and WLAN networks so that they appear as a single
unified network, click Bridge Mode.
Traffic from the WLAN to the LAN will be allowed to pass freely, and the LAN
and WLAN will share a single IP address range.
Note: This option creates a bridge called "default-bridge", which includes the WLAN
and the LAN. If desired, you can later remove this bridge by running the Wireless
Configuration Wizard again, and choosing Firewall Mode. For information on bridges,
see Using Bridges on page 217.
• To isolate the LAN from the WLAN, click Firewall Mode.
The WLAN and LAN will be assigned separate, isolated IP networks, and traffic
from the WLAN to the LAN will be subjected to the defined firewall policy.
By default, traffic from the WLAN to the LAN will be blocked, and traffic from
the LAN to the WLAN will be allowed. To allow traffic from the WLAN to the
LAN, you must create firewall rules. For information, see Using Firewall Rules.
11. Click Next.
WPA-Personal
If you chose WPA-Personal, the Wireless Configuration-WPA-Personal dialog box appears.