User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Overview
268 Check Point Safe@Office User Guide
You can configure up to seven WDS links, in addition to the primary WLAN. For
information on configuring WDS links, see Configuring WDS Links on page 298.
Note: All access points in a WDS must use the same radio channel for the WDS link
and for communicating with wireless stations. Therefore, using WDS may have a
negative impact on wireless throughput. In this case, it is recommended to use a
traditional wired backbone to connect the access points, instead of WDS links.
Figure 25: Redundant Loop of Access Points Linked by WDS and STP