User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Restoring Traffic Shaper Defaults
Chapter 9: Using Traffic Shaper 261
Restoring Traffic Shaper Defaults
If desired, you can reset the Traffic Shaper bandwidth policy to use the four predefined
classes, and restore these classes to their default settings. For information on these classes
and their defaults, see Predefined QoS Classes on page 254.
Note: This will delete any additional classes you defined in Traffic Shaper
and reset all rules to use the Default class.
If one of the additional classes is currently used by a rule, you cannot
reset Traffic Shaper to defaults. You can determine whether a class is in
use or not, by viewing the Rules page.
To restore Traffic Shaper defaults
1. Click Network in the main menu, and click the Traffic Shaper tab.
The Quality of Service Classes page appears.
2. Click Restore Defaults.
A confirmation message appears.
3. Click OK.