User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Adding and Editing Classes
258 Check Point Safe@Office User Guide
Note: Traffic Shaper may not enforce guaranteed rates and relative weights for
incoming traffic as accurately as for outgoing traffic. This is because Traffic Shaper
cannot control the number or type of packets it receives from the Internet; it can
only affect the rate of incoming traffic by dropping received packets. It is therefore
recommended to enable traffic shaping for incoming traffic only if necessary. For
information on enabling Traffic Shaper for incoming and outgoing traffic, see Using
Internet Setup on page 102.
6. Click Next.
The Step 3 of 3: Save dialog box appears with a summary of the class.
7. Type a name for the class.
For example, if you are creating a class for high priority Web connections, you can
name the class "High Priority Web".
8. Click Finish.
The new class appears in the Quality of Service Classes page.