User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Sample Implementation on Two Gateways
248 Check Point Safe@Office User Guide
3. Connect the LAN network computers of Gateways A and B to hub 1.
4. Connect the DMZ network computers of Gateways A and B to hub 2.
5. Do the following on Gateway A:
a. Set the gateway's internal IP addresses and network range to the values
specified in the table above.
See Changing IP Addresses on page 156.
b. Click Setup in the m
a
in menu, and click the High Availability tab.
The High Availability page appears.
c. Select the Gateway High Availability check box.
The Gateway High Availability area is enabled. The LAN and DMZ networks are
listed.
d. Next to LAN, select the HA check box.
e. In the LAN network's Virtual IP field, type the default gateway IP address
192.168.100.3.
f. Next to DMZ, select the HA check box.
g. In the DMZ network's Virtual IP field, type the default gateway IP address
192.168.101.3.
h. Click the Synchronization radio button next to DMZ.
i. In the My Priority field, type "100".
The high priority means that Gateway A will be the Active Gateway.
j. In the Internet - Primary field, type "20".
Gateway A will reduce its priority by 20, if its primary Internet connection goes
down.
k. In the Internet - Secondary field, type "30".
Gateway A will reduce its priority by 30, if its secondary Internet connection goes
down.
l. Click Apply.
A success message appears.