User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring High Availability on a Gateway
244 Check Point Safe@Office User Guide
This can be any unused IP address in the network, and must be the same for all
gateways.
You can assign a virtual IP address to any internal interface, as well as to "LAN Static
IP" Internet connections (that is, LAN connections for which the Obtain IP address
automatically (using DHCP) check box is cleared).
6. Click the Synchronization radio button next to the network you want to use as
the synchronization interface.
Note: The synchronization interface must be the same for all gateways, and must
always be connected and enabled on all gateways. Otherwise, multiple appliances
may become active, causing unpredictable problems.
The synchronization interface cannot be an Internet connection or a wireless
interface.
7. Complete the fields using the information the following table.
8. Click Apply.
A success message appears.
9. If desired, configure WAN HA for both the primary and secondary Internet
connection.
This setting should be the same for all gateways. For further information, see the Do
not connect if this gateway is in passive state field in Using Internet Setup on page
102.
10. If you configured a virtual
IP address for the WAN or WAN2 interface,
configure the
Internet connection to use the "Static IP" connection method.
See Using Internet Setup on page 102.