User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring High Availability on a Gateway
242 Check Point Safe@Office User Guide
Configuring High Availability on a Gateway
The following procedure explains how to configure HA on a single gateway. You must
perform this procedure on each Safe@Office appliance that you want to include in the HA
cluster.
To configure HA on a Safe@Office appliance
1. Set the appliance’s internal IP addresses and network range.
Each appliance must have a different internal IP address.
See Changing IP Addresses on page 156.
2. Click Setup in the m
a
in menu, and click the High Availability tab.
The High Availability page appears.
3. Select the Gateway High Availability check box.