User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Adding Internet Connections to Bridges
Chapter 7: Using Bridges 233
Adding Internet Connections to Bridges
To add an Internet connection to a bridge
1. Click Network in the main menu, and click the Internet tab.
The Internet page appears.
2. Next to the desired Internet connection, click Edit.
The Internet Setup page appears.
3. In the Port drop-down list, specify the port that the Internet connection should
use, by doing one of the following:
• To use the ADSL port, select ADSL.
This option is available in ADSL models only.
• To use the WAN port, select WAN.
This option is available in non-ADSL models only.
• To use the DMZ/WAN2 port, select WAN2.
4. Do one of the following:
• To configure a Bridged PPPoA connection, in the Connection Type field, select
PPPoA.
This option is available in ADSL models only.
• Otherwise, in the Connection Type field, select Bridged.