User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Adding Internal Networks to Bridges
232 Check Point Safe@Office User Guide
In this field… Do this…
Spanning Tree Protocol - Port
Priority
Select the port's priority.
The port's priority is combined with the port's logical number to
create the port's ID. The port with the lowest ID is elected as
the root port, which forwards frames out of the bridge. The
other ports in the bridge calculate the least-cost path to the
root port, in order to eliminate loops in the topology and
provide fault tolerance.
To increase the chance of this port being elected as the root
port, select a lower priority.
Note: If you select the same priority for all ports, the root port
will be elected based on the port's logical number.
The default value is 128.
This field only appears if the bridge uses STP.