User Manual Part 1

Adding and Editing Bridges
226 Check Point Safe@Office User Guide
Table 36: Bridge Configuration Fields
In this field… Do this…
Network Name Type a name for the bridge.
Firewall Between Members Specify whether the firewall should be enabled between
networks on this bridge, by selecting one of the following:
• Enabled. The firewall is enabled, and it will inspect
traffic between networks on the bridge, enforcing
firewall rules and SmartDefense protections. This is
the default value.
• Disabled. The firewall is disabled between networks
on the bridge.
Non IP Traffic Specify how the firewall should handle non-IP protocol traffic
between networks on this bridge, by selecting one of the
following:
• Block. The firewall will block all non-IP protocol
traffic on the bridge. This is the default value.
• Pass. The firewall will allow all non-IP protocol traffic
on the bridge and process it as described in Using
Bridges on page 217.
Span
nin
g Tree Protocol Specify whether to enable STP for this bridge, by selecting one
of the following:
• Enabled. STP is enabled.
• Disabled. STP is disabled. This is the default value.
If you selected Enabled, the Bridge Priority field appears.