User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Workflow
Chapter 7: Using Bridges 223
Workflow
To use a bridge
1. Add a bridge.
See Adding and Editing Bridges on page 224.
2. Add the desired internal networks to the bridge.
See Adding Internal Networks to Bridg
es on page 228.
3. Add the desired Internet connections to t
h
e bridge.
See Adding Internet Connections to Bridges on page 233.
4. If you enable
d the firewall between networks on t
his bridge, add security rules
and VStream Antivirus rules as needed.
Figure 22: Link Redundancy with STP