User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Overview
222 Check Point Safe@Office User Guide
Multiple Bridges and Spanning Tree Protocol
When using multiple bridges, you can enable fault tolerance and optimal packet routing, by
configuring Spanning Tree Protocol (STP - IEEE 802.1d). When STP is enabled, each
bridge communicates with its neighboring bridges or switches to discover how they are
interconnected. This information is then used to eliminate loops, while providing optimal
routing of packets. STP also uses this information to provide fault tolerance, by re-
computing the topology in the event that a bridge or a network link fails.
Figure 21: Dual Redundant Bridges with STP