User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Managing Ports
Chapter 6: Managing Your Network 215
Resetting Ports to Defaults
You can reset the Safe@Office appliance's ports to their default link configurations
("Automatic Detection") and default assignments (shown in the following table).
Table 35: Default Port Assignments
Port Default Assignment
LAN 1-4 LAN
DMZ / WAN2 DMZ
WAN This port is always assigned to the WAN.
ADSL This port is always assigned to the WAN.
Serial Console
Note: Resetting ports to their defaults may result in the loss of your Internet
connection. Therefore, it is recommended to be particularly careful when performing
this procedure remotely.