User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Network Settings
Chapter 6: Managing Your Network 181
11. Click Apply.
A warning message appears.
12. Click OK.
A success message appears.
13. Click Network in the main menu, and click the Ports tab.
The Ports page appears.
14. In the DMZ/WAN2 drop-down list, select VLAN Trunk.
15. Click Apply.
The DMZ/WAN2 port now operates as a VLAN Trunk port. In this mode, it will not
accept untagged packets.
16. Configure a VLAN trunk (802.1Q) port on the VLAN-aware switch, according
to the vendor instructions. Define the same VLAN IDs on the switch.
17. Connect the Safe@Office appliance's DMZ/WAN2 port to the VLAN-aware
switch's VLAN trunk port.
Deleting VLANs
To delete a VLAN
1. If the VLAN is port-based, do the following:
a. Click Network in the main menu, and click the Ports tab.
The Ports page appears.
b. Remove all port assignments to the VLAN, by selecting other networks
in the drop-down lists.
c. Click Apply.
2. Delete any firewall rules or VStream Antivirus rules that use this VLAN.
3. Click Network in the main menu, and click the My Network tab.
The My Network page appears.