User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Network Settings
Chapter 6: Managing Your Network 179
5. In the Mode drop-down list, select Enabled.
The fields are enabled.
6. In the IP Address field, type the IP address of the VLAN network's default
gateway.
Note: The VLAN network must not overlap other networks.
7. In the Subnet Mask field, type the VLAN's internal network range.
8. If desired, enable or disable Hide NAT.
See Enabling/Disabling Hide NAT on page 157.
9. If desired, configure a DHCP server.
See Configuring a DHCP Serve
r on page 158.
10. Click Apply.
A warning message appear
s.
11. Click OK.
A success message appears.
12. Click Network in the main menu, and click the Ports tab.
The Ports page appears.
13. Next to the LAN port you want to assign, click Edit.
The Port Setup page appears.
14. In the Assign to network drop-down list, select the VLAN network's name.
You can assign more than one port to the VLAN.
15. Click Apply.