User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Network Settings
Chapter 6: Managing Your Network 173
Note: OfficeMode requires either Check Point SecureClient or an L2TP client to be
installed on the VPN clients. It is not supported by Check Point SecuRemote.
When OfficeMode is not supported by the VPN client, traditional mode will be used
instead.
To configure the OfficeMode network
1. Click Network in the main menu, and click the My Network tab.
The My Network page appears.
2. In the OfficeMode network's row, click Edit.
The Edit Network Settings page appears.
3. In the Mode drop-down list, select Enabled.
The fields are enabled.
4. In the IP Address field, type the IP address to use as the OfficeMode network's
default gateway.
Note: The OfficeMode network must not overlap other networks.
5. In the Subnet Mask text box, type the OfficeMode internal network range.
6. If desired, enable or disable Hide NAT.
See Enabling/Disabling Hide NAT on page 157.
7. If desired, configure DHCP options.
See Configuring DHCP Serve
r Options on page 164.
8. Click Apply.
A warning message
appear
s.
9. Click OK.
A success message appears.