User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Network Settings
Chapter 6: Managing Your Network 163
The Automatic DHCP range check box is disabled, and new fields appear.
4. In the Primary DHCP Server IP field, type the IP address of the primary DHCP
server.
5. In the Secondary DHCP Server IP field, type the IP address of the DHCP server
to use if the primary DHCP server fails.
6. Click Apply.
A warning message appears.
7. Click OK.
A success message appears
8. If your computer is configured to obtain its IP address automatically (using
DHCP), and either the Safe@Office DHCP server or another DHCP server is
enabled, restart your computer.
Your computer obtains an IP address in the DHCP address range.