User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Network Settings
160 Check Point Safe@Office User Guide
Configuring the DHCP Address Range
By default, the Safe@Office DHCP server automatically sets the DHCP address range.
The DHCP address range is the range of IP addresses that the DHCP server can assign to
network devices. IP addresses outside of the DHCP address range are reserved for
statically addressed computers.
If desired, you can set the Safe@Office DHCP range manually.
To configure the DHCP address range
1. Click Network in the main menu, and click the My Network tab.
The My Network page appears.
2. In the desired network's row, click Edit.
The Edit Network Settings page appears.
3. Do one of the following:
• To allow the DHCP server to set the IP address range, select the Automatic
DHCP range check box.
• To set the DHCP range manually:
1) Clear the Automatic DHCP range check box.